Toyota CH-R Service Manual: Rear Door Belt Moulding

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR BUMPER ARM SUB-ASSEMBLY LH (for USA and Canada) (a) Install the rear bumper arm sub-assembly LH with the 4 bolts. Torque: 18 N·m {184 kgf·cm ...

Components
COMPONENTS ILLUSTRATION *1 REAR DOOR BELT REAR SEAL *2 REAR DOOR BELT SEAL *3 REAR DOOR GLASS INNER WEATHERSTRIP ...

Other materials:

Toyota CH-R Service Manual > Airbag System: TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. DTCs are displayed by blinking of the SRS warning light. HINT: When multiple warning lights in the combination meter blink continuously, a short to ground in the wiring or an ECU connected to terminal T ...

Toyota CH-R Service Manual > Front Speed Sensor: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. The front speed sensor rotor is a component of the front axle hub sub-assembly. If the front speed sensor rotor is malfunctioning, replace ...

© 2017-2020 Copyright www.tochr.net
0.0229