INSTALLATION
PROCEDURE
1. INSTALL REAR BUMPER ASSEMBLY
(a) Engage the claws as shown in the illustration.
![]() |
Install in the Direction |
(b) Engage the claws to install the rear bumper assembly as shown in the illustration.
HINT:
Use the same procedure for the RH side and LH side.
![]() |
Install in the Direction |
(c) Install the 2 bolts.
(d) Engage the hook. |
|
(e) Engage claws to install the No. 1 rear bumper plate.
HINT:
Use the same procedure for the RH side and LH side.
(f) Install the 6 clips.
(g) Remove the protective tape.
2. INSTALL QUARTER OUTSIDE MOULDING LH
(a) Engage the clips and claws to install the quarter outside moulding LH.
![]() |
Install in this Direction |
(b) Install the 2 screws.
(c) Remove the protective tape.
3. INSTALL QUARTER OUTSIDE MOULDING RH
HINT:
Use the same procedure as for the LH side.
4. INSTALL REAR BUMPER SIDE SEAL LH
(a) Install the rear bumper side seal LH with the 7 clips.
5. INSTALL REAR BUMPER SIDE SEAL RH
HINT:
Use the same procedure as for the LH side.
Toyota CH-R Owners Manual > Using the driving support systems: Driving mode select
In response to driving conditions, one of 3 drive modes can be selected.
Select the drive mode
■ Changing the driving mode To select the drive mode, perform
operations on the multi-information display.
1. Press
or
of meter control switches and select
.
2. Press
or
of the met ...
Toyota CH-R Service Manual > Smart Key System(for Entry Function): System Description
SYSTEM DESCRIPTION
MULTI CHANNEL FUNCTION
(a) The electrical key transmitter sub-assembly and electrical key and TPMS receiver
assembly can operate on two different RF channels. When an electrical key transmitter
sub-assembly is brought within an exterior detection area, key verification begin ...