COMPONENTS
ILLUSTRATION
|
*A |
for TMMT Made |
*B |
for TMC Made |
|
*1 |
DOOR FRAME UPPER GARNISH |
*2 |
FRONT DOOR FIX WINDOW GLASS |
|
*3 |
FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY |
*4 |
FRONT DOOR FRONT WINDOW FRAME MOULDING |
|
*5 |
FRONT DOOR GLASS RUN |
*6 |
FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY |
|
*7 |
FRONT DOOR UPPER WINDOW FRAME MOULDING |
*8 |
FRONT DOOR WEATHERSTRIP |
|
*9 |
RIVET |
*10 |
FRONT DOOR PANEL SUB-ASSEMBLY |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
|
Anti-rust coating |
- |
- |
|
★ |
Precoated part |
- |
- |
ILLUSTRATION
|
*1 |
COWL SIDE TRIM BOARD |
*2 |
FRONT DOOR SCUFF PLATE |
InstallationToyota CH-R Service Manual > Wheel Opening Moulding(for Rear): Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE NO. 1 BODY OUTSIDE MOULDING PAD
(a) Remove the No. 1 body outside moulding pad (double-sided tape).
HINT:
Do not pu ...
Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Precaution
PRECAUTION
PRECAUTIONS WHEN USING TECHSTREAM
(a) After all DTCs are cleared, check if the malfunction occurs again 6 seconds
after turning the ignition switch ON.
PRECAUTIONS FOR THE KEY
(a) The key is a precision instrument. Be sure to observe the following:
(1) Do not drop or strike the key ...