If a wheel is bent, cracked or heavily corroded, it should be replaced. Otherwise, the tire may separate from the wheel or cause a loss of handling control.
Wheel selection
When replacing wheels, care should be taken to ensure that they are equivalent to those removed in load capacity, diameter, rim width and inset*.
Replacement wheels are available at your Toyota dealer.
*: Conventionally referred to as "offset".
Toyota does not recommend using the following:
Aluminum wheel precautions (if equipped)
■When replacing wheels The wheels of your vehicle are equipped with tire pressure warning valves and transmitters that allow the tire pressure warning system to provide advance warning in the event of a loss in tire inflation pressure.
Whenever wheels are replaced, tire pressure warning valves and transmitters must be installed.
■When replacing wheels
■When installing the wheel nuts
Installing the nuts with the tapered ends facing outward can cause the wheel to break and eventually cause the wheel to come off while driving, which could lead to an accident resulting in death or serious injury.
Oil and grease may cause the wheel nuts to be excessively tightened, leading to bolt or disc wheel damage. In addition, the oil or grease can cause the wheel nuts to loosen and the wheel may fall off, causing an accident and resulting in death or serious injury. Remove any oil or grease from the wheel bolts or wheel nuts.
■Use of defective wheels prohibited Do not use cracked or deformed wheels.
Doing so could cause the tire to leak air during driving, possibly causing an accident.
■Replacing tire pressure warning valves and transmitters
Tire pressure warning valves and transmitters may not work properly with non-genuine wheels.
Toyota CH-R Service Manual > Ambient Light: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY
(a) Engage the claws to install the No. 1 interior illumination light
assembly.
*a
Clamp
...
Toyota CH-R Service Manual > Hood: Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
*a
Centering Bolt
*b
Standard Bolt
HINT:
Centering bolts are used to install the hood hinges and hood lock. The
hood and hood lock cannot be adjusted with the centering bolts installed.
...