Listed below are the general maintenance items that should be performed at the intervals specified in the "Owner's Warranty Information Booklet" or "Owner's Manual Supplement/Scheduled Maintenance Guide". It is recommended that any problem you notice should be brought to the attention of your Toyota dealer or qualified service shop for advice.
Engine compartment
| Items | Check points |
| Battery | Check the connections. |
| Brake fluid | Is the brake fluid at the correct level? |
| Engine coolant | Is the engine coolant at the correct level? |
| Engine oil | Is the engine oil at the correct level? |
| Exhaust system | There should not be any fumes or strange sounds. |
| Radiator/condenser | The radiator and condenser should be free of foreign objects. |
| Washer fluid | Is there sufficient washer fluid? |
Vehicle interior
| Items | Check points |
| Accelerator pedal |
|
| Continuously variable transmission "Park" mechanism |
|
| Brake pedal |
|
| Brakes |
|
| Items | Check points |
| Head restraints |
|
| Indicators/buzzers |
|
| Lights |
|
| Parking brake |
|
| Seat belts |
|
| Seats |
|
| Steering wheel |
|
Vehicle exterior
| Items | Check points |
| Doors |
|
| Engine hood |
|
| Fluid leaks |
|
| Tires |
|
| Windshield wipers/rear window wiper |
|
■If the engine is running Turn the engine off and ensure that there is adequate ventilation before performing maintenance checks.
Maintenance requirements
Emission inspection and maintenance (I/M) programsToyota CH-R Service Manual > Front Door Belt Moulding: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY
Install in this Direction
(a) Engage the claws to ...
Toyota CH-R Service Manual > Automatic High Beam System: Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether a part
is faulty or not.
HINT:
Using the Techstream to read the Data List allows the ...