INSPECTION
PROCEDURE
1. INSPECT FRONT STABILIZER LINK ASSEMBLY
|
(a) Inspect the turning torque of the ball joint. (1) Secure the front stabilizer link assembly in a vise using aluminum plates. NOTICE: Do not overtighten the vise. (2) Install the nut to the front stabilizer link assembly stud. (3) Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn. Turning Torque: 0.05 to 1.96 N*m (0.6 to 19 kgf*cm, 0.5 to 17 in.*lbf) HINT: If the turning torque is not within the specified range, replace the front stabilizer link assembly with a new one. (4) Turn the stud to check that the stud does not catch and there is no play HINT: If the stud catches or there is play while turning, replace the front stabilizer link assembly with a new one. |
|
(b) Inspect the dust cover.
(1) Check that the dust cover is not cracked and that there is no grease on it.
HINT:
If the dust cover is cracked or there is grease on it, replace the front stabilizer link assembly with a new one.
Removal
InstallationToyota CH-R Service Manual > Navigation System: Extension Module Disconnected 2 (B1543)
DESCRIPTION
If the radio and display receiver assembly cannot detect the navigation ECU for
a certain period of time (90 seconds) after the engine switch is turned on (ACC)
and the radio and display receiver assembly confirms that the information is missing
by checking past navigation ECU rec ...
Toyota CH-R Service Manual > Rocker Panel Moulding: Components
COMPONENTS
ILLUSTRATION
*1
REAR WHEEL HOUSE FRONT PLATE
*2
ROCKER PANEL MOULDING
●
Non-reusable part
-
-
ILLUSTRATION
*1
ROCKER PANEL MOULDING PAD
-
...