Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY

(a) Secure the front axle assembly in a vise using aluminum plates.

NOTICE:

Do not overtighten the vise.

(b) Install the front lower ball joint assembly to the front axle assembly with the nut.

Torque:

133 N·m {1356 kgf·cm, 98 ft·lbf}

NOTICE:

  • Do not apply lubricants to the ball joint stud taper and threads.
  • Remove any foreign matter from the contact surface of the steering knuckle and ball joint stud taper.

(c) Install a new cotter pin.

NOTICE:

Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.

2. INSTALL FRONT AXLE ASSEMBLY

Click here

    Inspection
    INSPECTION PROCEDURE 1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY (a) Inspect the turning torque of the ball joint. (1) Secure the front lower ball joint assembly in a vise using alumin ...

    Front Lower Suspension Arm
    ...

    Other materials:

    Toyota CH-R Service Manual > Automatic Headlight Beam Level Control System: Parts Location
    PARTS LOCATION ILLUSTRATION *1 BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU) *2 HEADLIGHT UNIT ASSEMBLY LH - HEADLIGHT LEVELING MOTOR *3 HEADLIGHT UNIT ASSEMBLY RH - HEADLIGHT LEVELING MOTOR *4 HEADL ...

    Toyota CH-R Service Manual > Smart Key System(for Start Function): Brake Signal Malfunction (B2284)
    DESCRIPTION This DTC is stored when the brake signal sent via direct line and the brake signal sent via CAN communication do not match. DTC No. Detection Item DTC Detection Condition Trouble Area Note B2284 Brake ...

    Toyota C-HR (AX20) 2023-2025 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0076