COMPONENTS
ILLUSTRATION
|
*1 |
NO. 2 PARKING BRAKE WIRE ASSEMBLY |
*2 |
PARKING BRAKE ACTUATOR ASSEMBLY |
|
*3 |
O-RING |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
|
Lithium soap base glycol grease |
- |
- |
ILLUSTRATION
|
*1 |
REAR DISC BRAKE ANTI-SQUEAL SHIM KIT |
*2 |
REAR DISC BRAKE CYLINDER ASSEMBLY |
|
*3 |
REAR DISC BRAKE PAD |
*4 |
REAR FLEXIBLE HOSE |
|
*5 |
REAR DISC BRAKE ANTI-SQUEAL SHIM |
*6 |
GASKET |
|
*7 |
UNION BOLT |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
ILLUSTRATION
|
*1 |
REAR DISC |
*2 |
REAR DISC BRAKE CYLINDER MOUNTING |
|
*3 |
REAR NO. 1 DISC BRAKE CYLINDER SLIDE PIN |
*4 |
REAR NO. 2 DISC BRAKE CYLINDER SLIDE PIN |
|
*5 |
REAR DISC BRAKE BUSHING DUST BOOT |
*6 |
REAR DISC BRAKE PAD SUPPORT PLATE |
|
*7 |
REAR DISC BRAKE CYLINDER SLIDE BUSHING |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
|
Lithium soap base glycol grease |
- |
- |
ILLUSTRATION
|
*1 |
CYLINDER BOOT |
*2 |
PISTON SEAL |
|
*3 |
REAR DISC BRAKE BLEEDER PLUG |
*4 |
REAR DISC BRAKE BLEEDER PLUG CAP |
|
*5 |
REAR DISC BRAKE PISTON |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
RemovalToyota CH-R Service Manual > Front Seat Assembly: Precaution
PRECAUTION
HINT:
The following procedures are used to prevent wrinkles from forming when
installing the seat cover. Make sure to follow the procedures correctly.
The shape of the seat shown in the illustration may differ from the
actual seat.
SEAT COVER SET
...
Toyota CH-R Service Manual > Tire Pressure Warning Valve: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced during
tire pressure warning valve and transmitter removal/installation are shown below.
Repl ...