Toyota CH-R Owners Manual: For safe driving

WARNING Observe the following precautions.

Failure to do so may result in death or serious injury.

• Do not adjust the position of the driver's seat while driving.

  Doing so could cause the driver to lose control of the vehicle.

• Do not place a cushion between the driver or passenger and the seatback.

  A cushion may prevent correct posture from being achieved, and reduce the effectiveness of the seat belt and head restraint.

• Do not place anything under the front seats.

  Objects placed under the front seats may become jammed in the seat tracks and stop the seat from locking in place. This may lead to an accident and the adjustment mechanism may also be damaged.

• Always observe the legal speed limit when driving on public roads.
• When driving over long distances, take regular breaks before you start to feel tired.

  Also, if you feel tired or sleepy while driving, do not force yourself to continue driving and take a break immediately.

Before driving

Floor mat Use only floor mats designed specifically for vehicles of the same model and model year as your vehicle. Fix them securely in place onto the carpet. 1. Insert the retaining hooks (clips) ...

Seat belts

Make sure that all occupants are wearing their seat belts before driving the vehicle. Correct use of the seat belts Extend the shoulder belt so that it comes fully over the shoulder, but does ...

Other materials:

Toyota CH-R Service Manual > Front Door Belt Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the front door belt moulding removal/installation are shown below. Necessary Procedure After Part ...

Toyota CH-R Service Manual > Meter / Gauge System: Initialization
INITIALIZATION MAINTENANCE REQUIRED REMINDER RESET PROCEDURE (a) Turn the ignition switch ON. (b) Using the steering pad switch assembly, display the setting display on the multi-information display. (c) Select "Maintenance System" from the setting display and perform initialization ...