DESCRIPTION
This DTC is set when the DCM (Telematics Transceiver) detects either of the following conditions.
When this DTC is set, the BUB (Back-Up Battery) must be replaced.
BUB (Back-Up Battery) degradation DTC B15EC is not reported in deactive mode.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B15EC |
Backup Battery Degradation |
BUB (Back-Up Battery) is used up. |
BUB (Back-Up Battery) |
CAUTION / NOTICE / HINT
NOTICE:
Click here
HINT:
Before performing this diagnostic procedure, make sure to perform Health Check and confirm that the DCM/VIN registration information is correct.
Click here
PROCEDURE
|
1. |
CHECK DTC |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch ON and wait for 10 seconds.
(d) Turn the Techstream on.
(e) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs(f) Recheck for DTCs.
Body Electrical > Telematics > Trouble Codes|
Result |
Proceed to |
|---|---|
|
DTC B15EC is output |
A |
|
DTC B15EC is not output |
B |
| A | |
REPLACE BUB (BACK-UP BATTERY) |
| B | |
CHECK FOR INTERMITTENT PROBLEMS |
Telephone Microphone Error (B1572)
Short in Telephone SUB Antenna Circuit (B1536,B1537)Toyota CH-R Service Manual > Navigation System: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Navigation System
DTC No.
Detection Item
Link
B1324
Lost Communication with Meter
B153A
GVIF Disconnected (from Extension Module to H/U)
...
Toyota CH-R Service Manual > Smart Key System(for Start Function): Power Source Mode does not Change to ON (IG and ACC)
DESCRIPTION
If any of the following operations are performed, the certification ECU (smart
key ECU assembly) receives a signal, and changes the power source mode.
With the electrical key transmitter sub-assembly in the cabin, the engine
switch is pressed.
When the transmitter batt ...