DATA LIST / ACTIVE TEST
DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Data List.
(e) According to the display on the Techstream, read the "Data List".
Body Electrical > Telematics > Data List
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|---|
Emergency Switch |
Manual (SOS) switch |
OFF or ON |
OFF: Manual (SOS) switch not pressed ON: Manual (SOS) switch pressed |
- |
Current Com Back-Up Battery |
BUB (Back-Up Battery) installation history |
without or with |
without: This DCM (telematics transceiver) has no record of a BUB (Back-Up Battery) ever being connected with: BUB (Back-Up Battery) was connected at some point (does not guarantee that BUB (Back-Up Battery) is currently connected) |
- |
MIN |
Phone number to be assigned to telematics (for communication carrier) |
Display the phone number for communication carrier |
Display the phone number for communication carrier |
- |
MDN |
Phone number to be assigned to telematics (for customer) |
Display the phone number for customer |
Display the phone number for customer |
- |
MEID |
Only MEID (cellular Module ID) is displayed on the Techstream. Serial number to be assigned to cellular module in telematics. |
Display the cellular module ID number |
Display the cellular module ID number |
- |
Number of Trouble Codes |
The number of the DTC which is currently output |
Min.: 0 to Max.: 255 |
Number of DTCs will be displayed |
- |
Toyota CH-R Service Manual > Continuously Variable Transaxle System: Check Mode Procedure
CHECK MODE PROCEDURE
DESCRIPTION
(a) Check mode has a higher sensitivity to malfunctions and can detect malfunctions
that cannot be detected in normal mode. Check mode can also detect all the malfunctions
that can be detected in normal mode. In check mode, DTCs are stored with 1 trip
detecti ...
Toyota CH-R Service Manual > Windshield Deicer System: Precaution
PRECAUTION
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine Swi ...