Toyota CH-R Service Manual: Voice Guidance does not Function

CAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

    Click here

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly may not operate normally.

PROCEDURE

1.

CHECK VOICE GUIDANCE SETTING

(a) Check that the voice guidance setting is not off.

OK:

Voice guidance setting is not off.

NG

SELECT VOICE VOLUME SETTING OTHER THAN "Off"

OK

2.

CHECK AUDIO FUNCTION

(a) Check that sound can be heard from a front speaker.

OK:

Sound can be heard.

OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Poor Sound Quality in All Modes (Low Volume)
    PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set bass, mid-range and treble to the initial values and check that the sound is normal. OK: The sound returns to normal. ...

    Cellular Phone Registration Failure
    CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be neede ...

    Other materials:

    Toyota CH-R Service Manual > K114 Continuously Variable Transaxle Fluid: Replacement
    REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the CVT fluid replacement are shown below. Necessary Procedure After Parts Removed/Installed/Re ...

    Toyota CH-R Service Manual > Seat Belt Warning System(w/ Occupant Classification System): Front Passenger Side Seat Belt Warning Light Malfunction
    DESCRIPTION When the ignition switch is turned ON, the occupant detection ECU sends signals to the airbag sensor assembly to indicate the state of the front seat inner belt assembly RH and also whether the front passenger seat is occupied. The airbag sensor assembly sends those signals to the ...

    © 2017-2020 Copyright www.tochr.net
    0.0174