Toyota CH-R Service Manual: Precaution

Toyota CH-R Service Manual / Theft Deterrent / Keyless Entry / Smart Key System(for Start Function) / Precaution

PRECAUTION

CAUTION REGARDING INTERFERENCE WITH ELECTRONIC DEVICES

CAUTION:

  • People with implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators should maintain a reasonable distance between themselves and the smart key system antennas. The radio waves may affect the operation of such devices. If necessary, the entry function can be disabled. Ask your dealer for details, such as the frequency of radio waves and timing of the emitted radio waves. Then, consult your doctor to see if you should disable the entry function.

    Click here

  • User of any electrical medical device other than implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators should consult the manufacturer of the device for information about its operation under the influence of radio waves. Radio waves could have unexpected effects on the operation of such medical devices.
  • Ask your dealer for details for disabling the entry function.

PRECAUTION WHEN USING TECHSTREAM

(a) When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.

PRECAUTION FOR REGISTRATION

(a) If replacing any of the following parts, refer to the registration procedures.

(1) Certification ECU (smart key ECU assembly)

(2) Steering lock ECU (steering lock actuator or upper bracket assembly)

(3) ECM

(4) Electrical key transmitter sub-assembly

(5) ID code box (immobiliser code ECU)

(6) Main body ECU (multiplex network body ECU)

(b) When the certification ECU (smart key ECU assembly) is replaced, the stored steering lock position will no longer match that of the steering lock ECU (steering lock actuator or upper bracket assembly) and it may not be possible to start the engine. Therefore, after replacement, perform the following procedure.

(1) Move the shift lever to P.

(2) With the engine switch off, open and close a door, and then start the engine.

    Parts Location
    PARTS LOCATION ILLUSTRATION *1 PARK/NEUTRAL POSITION SWITCH *2 STARTER ASSEMBLY *3 NO. 1 ENGINE ROOM RELAY BLOCK - IG2-MA ...

    System Diagram
    SYSTEM DIAGRAM Component Outline Engine switch Transponder key amplifier Turns on the power and starts the ...

    Other materials:

    Toyota CH-R Service Manual > Manual Headlight Beam Level Control System: Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by check ...

    Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Side-mounted Air Conditioner Pressure Sensor): Evaporator Temperature Sensor Circuit (B1413)
    DESCRIPTION The No. 1 cooler thermistor (evaporator temperature sensor) is installed to the evaporator in the air conditioner unit to detect the temperature of the cooled air that has passed through the evaporator, which is used to control the air conditioning system. It sends signals to the ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0106