Toyota CH-R Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the front seat airbag assemblies.

PROCEDURE

1. INSPECT FRONT SEAT AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the front seat airbag assemblies installed to the vehicle.

HINT:

The defects are as follows:

  • Scratches, broken or frayed threads on the surface of the front seatback assembly around the front seat airbag assemblies
  • Small cracks in the front seatback assembly around the front seat airbag assemblies
  • Significant discoloration on the front seatback assembly around the front seat airbag assemblies

OK:

No defects are found.

If any defects are found, replace the separate type front seatback pad or separate type front seatback cover with a new one.

2. INSPECT FRONT SEAT AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the front seat airbag assemblies removed from the vehicle.

HINT:

The defects are as follows:

  • Scratches, broken or frayed threads on the surface of the base fabric of the front seat airbag assemblies
  • Marks from being dropped
  • Deformation of the installation surface of the front seat airbag assemblies
  • Cracks or other damage to the wire harness or connector

OK:

No defects are found.

If any defects are found, replace the front seat airbag assembly with a new one.

    Components
    COMPONENTS ILLUSTRATION *1 FRONT SEAT AIRBAG ASSEMBLY - - Tightening torque for "Major areas involving basic vehicle perf ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Other materials:

    Toyota CH-R Service Manual > Rear Spoiler: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE NO. 2 REAR SPOILER (a) Remove the 2 screws. Remove in this Direction (b) Disengage the claws to remove the No. 2 rear spoiler as shown in the illustration. 2. REMOVE NO. 2 REAR SPOILER PROTECTOR HINT: Using the same procedure, re ...

    Toyota CH-R Service Manual > Power Steering System: Torque Sensor Zero Point Adjustment Undone (C1515)
    DESCRIPTION This DTC does not indicate a malfunction. The power steering ECU assembly stores this DTC when it determines that torque sensor zero point calibration has not been performed. DTC No. Detection Item DTC Detection Condition Trouble Area ...

    © 2017-2019 Copyright www.tochr.net
    0.0167