INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the ignition switch off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Before connecting the connector, check that the position of the white housing lock is as shown in the illustration.
|
*a |
Incorrect |
*b |
Correct |
(d) Connect the connector to the front airbag sensor.
|
*a |
White Housing Lock |
*b |
Connection is completed |
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
HINT:
|
(e) Engage the claw to install the front airbag sensor with the bolt. Torque: 9.0 N·m {92 kgf·cm, 80 in·lbf} NOTICE:
|
|
(f) Check that there is no looseness in the installed parts of the front airbag sensor.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
3. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here
4. INSPECT SRS WARNING LIGHT
Click here
RemovalToyota CH-R Service Manual > Airbag System: Short in Front Passenger Side Squib 2nd Step Circuit (B1815/54-B1818/54)
DESCRIPTION
The front passenger side squib 2nd step circuit consists of the airbag sensor
assembly and instrument panel passenger without door airbag assembly.
The airbag sensor assembly uses this circuit to deploy the airbag when deployment
conditions are met.
These DTCs are stored when a ma ...
Toyota CH-R Service Manual > Continuously Variable Transaxle Fluid: Components
COMPONENTS
ILLUSTRATION
*1
REFILL PLUG
*2
OVERFLOW PLUG
*3
NO. 1 TRANSMISSION OIL FILLER TUBE
*4
DRAIN PLUG
*5
NO. 1 ENGINE UNDER COVER
*6
REAR ENGINE U ...