PROBLEM SYMPTOMS TABLE
NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
HINT:
Symptom |
Suspected Area |
Link |
---|---|---|
Driver side seat belt warning light does not operate |
Refer to the "Driver side seat belt warning light does not operate" |
![]() |
Front passenger side seat belt warning light malfunction |
Refer to the "Front passenger side seat belt warning light malfunction" |
![]() |
Rear seat belt warning light malfunction |
Refer to the "Rear Seat Belt Warning Light Malfunction" |
|
Seat belt warning light does not operate for driver and front passenger seats |
Combination meter assembly |
|
Seat belt warning buzzer does not operate |
Check customized settings using the Techstream |
![]() |
Combination meter assembly |
|
Toyota CH-R Service Manual > Rear Crossing Traffic Alert Buzzer: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
the blind spot monitor buzzer removal/installation are shown below.
Necessary Procedures After P ...
Toyota CH-R Service Manual > Rear Bumper: Components
COMPONENTS
ILLUSTRATION
*1
QUARTER OUTSIDE MOULDING LH
*2
QUARTER OUTSIDE MOULDING RH
*3
REAR BUMPER ASSEMBLY
*4
REAR BUMPER SIDE SEAL LH
*5
REAR BUMPER SIDE SEAL RH
...