DESCRIPTION
When a new millimeter wave radar sensor assembly is installed, it receives vehicle specification information (destination) from the main body ECU (multiplex network body ECU) and stores the information.
DTC C1A02 is stored when the millimeter wave radar sensor assembly cannot store the vehicle specification information from the main body ECU (multiplex network body ECU).
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
C1A02 |
Vehicle Information Not Obtained |
At a vehicle speed of 50 km/h (31 mph) or higher the millimeter wave radar sensor assembly cannot store the vehicle specification information for approximately 0.1 seconds or more. |
Millimeter wave radar sensor assembly |
PROCEDURE
1. |
GO TO DYNAMIC RADAR CRUISE CONTROL SYSTEM |
Click here
NEXT | ![]() |
END |
Toyota CH-R Service Manual > Front Seat Inner Belt Assembly: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
the front seat inner belt assembly removal/installation are shown below.
Necessary Procedure Aft ...
Toyota CH-R Service Manual > Air Conditioning Pressure Sensor: Removal
REMOVAL
PROCEDURE
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFC-134a(R134a))
Click here
2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFO-1234yf(R1234yf))
Click here
3. REMOVE AIR CONDITIONER PRESSURE SENSOR (for VALEO Made)
(a) Disconnect the connector.
...