INSPECTION
PROCEDURE
1. INSPECT INNER REAR VIEW MIRROR ASSEMBLY
(a) Inspect the operation of the electrochromic inner rear view mirror assembly.
|
*a |
Black Colored Tape |
*b |
Forward Sensor |
|
*c |
Bright |
*d |
Dark |
|
*e |
Battery |
*f |
AUTO Switch |
|
*g |
Component without harness connected (Inner Rear View Mirror Assembly) |
- |
- |
(1) Connect a positive (+) lead from the battery to terminal 4 and a negative (-) lead to terminal 1.
(2) Press the AUTO switch.
(3) Apply black colored tape to the forward sensor to prevent it from sensing.
(4) Light up the mirror with an electric light, and check that the mirror surface changes from bright to dark.
OK:
Mirror surface changes from bright to dark.
If the result is not as specified, replace the inner rear view mirror assembly.
Components
RemovalToyota CH-R Service Manual > Continuously Variable Transaxle Assembly(when Not Using The Engine Support Bridge): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
continuously variable transaxle assembly removal/installation are shown below.
Necessary Proced ...
Toyota CH-R Service Manual > Navigation System: Radio Broadcast cannot be Received or Poor Reception
WIRING DIAGRAM
for TMMT Made
for TMC Made
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or
maintenance, performing initialization, registration or calibration may
be needed. Refer to Precaution for Navigation System.
Cl ...