Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - Switch body

Not pushed (ON)

Below 1 Ω

Pushed (OFF)

10 kΩ or higher

If the result is not as specified, replace the rear door courtesy light switch assembly.

*a

Component without harness connected

(Rear Door Courtesy Light Switch Assembly)

*b

Switch Body

    Components
    COMPONENTS ILLUSTRATION *A w/ Rear Seat Side Airbag *B w/o Rear Seat Side Airbag *1 REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Other materials:

    Toyota CH-R Service Manual > Rear Door Outside Moulding: Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR DOOR UPPER OUTSIDE MOULDING PAD (a) Remove the rear door upper outside moulding pad. ...

    Toyota CH-R Service Manual > Rear Axle Carrier: Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. TEMPORARILY INSTALL REAR AXLE CARRIER SUB-ASSEMBLY (a) Temporarily install the rear axle carrier sub-assembly to ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0085