Toyota CH-R Service Manual: Operation Check

OPERATION CHECK

CHECK FUNCTION

(a) Check that the key reminder warning buzzer sounds.

(1) With the driver door closed, insert the key into the ignition key cylinder and then make sure that the ignition switch is off or ACC.

(2) Check that the buzzer sounds intermittently if the driver door is opened.

(b) Check that the key reminder warning buzzer stops.

(1) Check that the buzzer stops sounding if any of the following operations is performed while the buzzer is sounding:

  • Close the driver door (driver door courtesy light switch is off).
  • Turn the ignition switch to ON.
  • Pull out the key from the ignition key cylinder.
    How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the key reminder warning system. *: Use the Techstream. PROCEDURE 1. VEHICLE ...

    Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

    Other materials:

    Toyota CH-R Service Manual > Generator: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures(adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the generator assembly removal/installation are shown below. Necessary Procedure After Parts Removed ...

    Toyota CH-R Service Manual > Personal Light: Installation
    INSTALLATION PROCEDURE 1. INSTALL MAP LIGHT ASSEMBLY (a) Connect each connector. (b) Engage the guide and clips to install the map light assembly as shown in the illustration. Install in this Direction (1) Install in this Direction (2) ...

    © 2017-2022 Copyright www.tochr.net
    0.0106