COMPONENTS
ILLUSTRATION
|
*A |
for Driver Side |
*B |
for Front Passenger Side |
|
*1 |
FRONT DOOR BELT SEAL |
*2 |
FRONT DOOR GLASS INNER WEATHERSTRIP |
|
*3 |
FRONT DOOR INSIDE HANDLE BEZEL PLUG |
*4 |
FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
|
*5 |
MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL |
*6 |
POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL |
ILLUSTRATION
|
*1 |
FRONT DOOR GLASS SUB-ASSEMBLY |
*2 |
FRONT DOOR SERVICE HOLE COVER |
|
*3 |
FRONT DOOR WINDOW REGULATOR ASSEMBLY |
*4 |
NO. 2 FRONT DOOR SERVICE HOLE COVER |
|
*5 |
POWER WINDOW REGULATOR MOTOR ASSEMBLY |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
|
MP grease |
InspectionToyota CH-R Service Manual > Blower Unit(for Denso Made): Disassembly
DISASSEMBLY
PROCEDURE
1. PRECAUTION
NOTICE:
Make sure to perform initialization after replacing the No. 1 blower damper servo
sub-assembly. If initialization is not performed, the air conditioner unit assembly
will not perform properly as the air conditioning amplifier assembly will not be
...
Toyota CH-R Service Manual > Vehicle Stability Control System: ABS Warning Light Remains ON
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination
meter assembly via CAN communication. If any of the following is detected, the ABS
warning light remains on:
The skid control ECU (brake actuator assembly) connector is disconnected
from the s ...