Toyota CH-R Service Manual: Front Passenger Side Power Window Switch

Toyota CH-R Service Manual / Window / Glass / Front Passenger Side Power Window Switch

Components

COMPONENTS

ILLUSTRATION

*1

POWER WINDOW REGULATOR SWITCH ASSEMBLY

*2

POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL

*3

FRONT DOOR UPPER ARMREST BASE PANEL

-

-

Removal

REMOVAL

PROCEDURE

1. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Click here

2. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Disengage the claws to remove the power window regulator switch assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

5 (UP) - 7 (GND)

Auto up or up position

Below 100 Ω

4 (DOWN) - 7 (GND)

Auto down or down position

Below 100 Ω

8 (AUTO) - 7 (GND)

Auto up or auto down position

Below 100 Ω

5 (UP) - 7 (GND)

Off

10 kΩ or higher

4 (DOWN) - 7 (GND)

Off

10 kΩ or higher

8 (AUTO) - 7 (GND)

Off

10 kΩ or higher

If the result is not as specified, replace the power window regulator switch assembly.

*a

Component without harness connected

(Power Window Regulator Switch Assembly)

(b) Check that the LED illuminates.

(1) Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.

OK:

Battery Connection

Specified Condition

Battery positive (+) → 3 (ILL+)

Battery negative (-) → 1 (ILL-)

LED illuminates

If the result is not as specified, replace the power window regulator switch assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Engage the claws to install the power window regulator switch assembly.

2. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Click here

    Installation
    INSTALLATION PROCEDURE 1. CLEAN BACK DOOR GLASS (a) When reusing the back door glass: (1) Using a scraper, remove any remaining adhesive residue from the back window glass. NOT ...

    Power Window Control System
    ...

    Other materials:

    Toyota CH-R Service Manual > Transmission Control Cable: Adjustment
    ADJUSTMENT PROCEDURE 1. SECURE VEHICLE (a) Fully apply the parking brake and chock a wheel. CAUTION: Make sure to apply the parking brake and chock a wheel before performing this procedure. If the vehicle is not secure and the shift lever is moved to N, the vehicle may sudd ...

    Toyota CH-R Service Manual > Meter / Gauge System: Open in Turn Signal Circuit (B1507,B1508)
    DESCRIPTION These DTCs are stored when the combination meter assembly detects an open in a turn signal light circuit, or a short in a turn signal light circuit or the hazard warning light circuit. DTC No. Detection Item DTC Detection Condition Troubl ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0063