Toyota CH-R Service Manual: How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the manual headlight beam level control system.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

NEXT

3.

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT

4.

PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

NEXT

5.

ADJUST, REPAIR OR REPLACE

NEXT

6.

CONFIRMATION TEST

NEXT

END

    System Diagram
    SYSTEM DIAGRAM ...

    System Description
    SYSTEM DESCRIPTION MANUAL HEADLIGHT BEAM LEVEL CONTROL SYSTEM The manual headlight beam level control system controls each headlight leveling motor based on the headlight leveling switch operation ...

    Other materials:

    Toyota CH-R Service Manual > Forced Release(for Tmmt Made): Operation Method
    OPERATION METHOD PROCEDURE 1. PRECAUTION Click here 2. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY Click here 3. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH Click here 4. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH HINT: Use the same procedure as for the LH side. ...

    Toyota CH-R Service Manual > Airbag System: Side Airbag Sensor Assembly No.2 Lost Communication (RH) (B162B/85,B162C/85)
    DESCRIPTION The side collision sensor RH circuit (bus 2) consists of the airbag sensor assembly and floor side airbag sensor RH. The floor side airbag sensor RH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbags and pretensioners should ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0075