FAIL-SAFE CHART
FAIL-SAFE FUNCTION (for LED Headlight)
(a) Headlight ECU sub-assembly
(1) The headlight ECU sub-assemblies stop light operation if any of the following malfunctions are detected.
Malfunction |
Multi-information Display Warning |
DTC Output |
||
---|---|---|---|---|
Lighting on/off |
LED light source malfunction |
Low beam |
Displayed |
Output |
High beam |
Not displayed |
Output |
||
Other than above (communication with main body ECU (multiplex network body ECU)) |
Displayed |
Output |
||
Automatic headlight beam level control system |
Displayed |
Output |
||
Power supply |
IG voltage line malfunction |
Displayed |
Output |
|
Other than an IG voltage line malfunction |
Not displayed |
Not output |
Toyota CH-R Service Manual > Stop Light Switch: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced during
the stop light switch assembly removal/installation are shown below.
Necessary Procedures after p ...
Toyota CH-R Owners Manual > Steps to take in an emergency: If your vehicle overheats
The following may indicate that your vehicle is overheating.
The needle of the engine coolant temperature gauge enters the red zone or
a loss of engine power is experienced (for example, the vehicle speed does not
increase).
Steam comes out from under the hood.
Correction procedures
...