Components
COMPONENTS
ILLUSTRATION
|
*1 |
HEADLIGHT LEVELING SWITCH |
*2 |
INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Click here
2. REMOVE HEADLIGHT LEVELING SWITCH
|
(a) Using a screw driver with its tip wrapped in protective tape, disengage the claws to remove the headlight leveling switch. |
|
Inspection
INSPECTION
PROCEDURE
1. INSPECT HEADLIGHT LEVELING SWITCH
(a) Voltage Check.
|
(1) Connect a positive (+) lead from the battery to terminal 1 (B) and a negative (-) lead to terminal 4 (E). |
|
(2) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
2 (T) - 4 (E) |
0 |
9.5 to 10.2 V |
|
1 |
8.1 to 8.8 V |
|
|
2 |
6.6 to 7.4 V |
|
|
3 |
5.2 to 6.0 V |
|
|
4 |
3.8 to 4.5 V |
|
|
5 |
2.4 to 3.1 V |
HINT:
(b) Illumination Inspection.
|
(1) Apply battery voltage to the headlight leveling switch and check that the switch illuminates. OK:
HINT: If the result is not as specified, replace the headlight leveling switch. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL HEADLIGHT LEVELING SWITCH
|
(a) Engage the claws to install the headlight leveling switch. |
|
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Click here
Headlight EcuToyota CH-R Service Manual > Maintenance: Fog Light Bulb
Components
COMPONENTS
ILLUSTRATION
*1
FOG LIGHT BULB
*2
FRONT FENDER LINER
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
...
Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Immobiliser System
DTC No.
Detection Item
Link
B2780
Push Switch / Key Unlock Warning Switch Malfunction
B2784
Antenna Coil Open / Short
...