INSPECTION
PROCEDURE
1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
(a) Check the resistance.
|
(1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the hazard warning signal switch assembly. |
|
(b) Check that the illumination lights.
(1) Apply battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.
OK:
|
Condition |
Specified Condition |
|---|---|
|
Battery positive (+) → Terminal 3 (ILL+) Battery negative (-) → Terminal 2 (ILL-) |
Illuminates |
If the result is not as specified, replace the hazard warning signal switch assembly.
Removal
InstallationToyota CH-R Service Manual > Front Passenger Airbag Assembly: Disposal
DISPOSAL
CAUTION / NOTICE / HINT
CAUTION:
Before performing pre-disposal deployment of any SRS part, review and closely
follow all applicable environmental and hazardous material regulations. Pre-disposal
deployment may be considered hazardous material treatment.
PROCEDURE
1. PRECAUTION
...
Toyota CH-R Owners Manual > Driving procedures: Turn signal lever
Operating instructions
Right turn
Lane change to the right (move the lever partway and release it)
The right hand signals will flash 3 times.
Lane change to the left (move the lever partway and release it)
The left hand signals will flash 3 times.
Left turn
■Turn signals can b ...