Toyota CH-R Service Manual: How To Proceed With Troubleshooting

Toyota CH-R Service Manual / Lighting (ext) / Automatic High Beam System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the automatic high beam system.

*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

3.	INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

4.	INSPECT CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Click here

Result	Proceed to
CAN communication system DTCs are not output	A
CAN communication system DTCs are output	B

GO TO CAN COMMUNICATION SYSTEM

5.	CHECK FOR DTC*

(a) Check for DTCs.

Click here

Body Electrical > Main Body > Trouble Codes

Result	Proceed to
DTCs are not output	A
DTCs are output	B

GO TO DIAGNOSTIC TROUBLE CODE CHART

6.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result	Proceed to
Fault is not listed in Problem Symptoms Table	A
Fault is listed in Problem Symptoms Table	B

GO TO PROBLEM SYMPTOMS TABLE

7.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Data List / Active Test

Click here

(b) Terminals of ECU

Click here

8.	ADJUST, REPAIR OR REPLACE

9.	CONFIRMATION TEST

END

Operation Check

OPERATION CHECK AUTOMATIC HIGH BEAM SYSTEM OPERATION CHECK (a) Check the operation of the automatic high beam indicator light. *a Automatic High Beam Indicator Light ...

Other materials:

Toyota CH-R Service Manual > Rear Suspension Member: Installation
INSTALLATION PROCEDURE 1. INSTALL HOLE PLUG (a) Install the 7 hole plugs to the rear suspension member sub-assembly as shown in the illustration. 2. INSTALL REAR SUSPENSION MEMBER HOLE COVER (a) Install the 4 rear suspension member hole covers to the rear suspension member sub-assembly. 3. ...

Toyota CH-R Owners Manual > Engine compartment: Battery
Check the battery as follows. ■ Battery exterior Make sure that the battery terminals are not corroded and that there are no loose connections, cracks, or loose clamps. Terminals Hold-down clamp ■ Checking battery fluid If there are lines on the side of the battery: Check that ...

Toyota CH-R Service Manual: How To Proceed With Troubleshooting

System Diagram

Operation Check

Other materials:

Toyota C-HR (AX20) 2023-2026 Owner's Manual

Toyota CH-R Owners Manual

Toyota CH-R Service Manual