Toyota CH-R Service Manual: Fail-safe Chart

FAIL-SAFE CHART

FAIL-SAFE FUNCTION

(a) Headlight ECU sub-assembly

(1) The headlight ECU sub-assemblies stop light operation if the following malfunctions are detected.

Malfunction

Multi-information Display Warning

DTC Output

Lighting on/off

LED light source malfunction

Low beam

Displayed

Output

High beam

Not Displayed

Output

Fan malfunction

Displayed

Output

Other than above (communication with main body ECU (multiplex network body ECU))

Displayed

Output

Automatic headlight beam level control system

Displayed

Output

Power supply

IG voltage line malfunction

Displayed

Output

Other than an IG voltage line malfunction

Not displayed

Not output

    Dtc Check / Clear
    DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / HL AutoLevelin ...

    Freeze Frame Data
    FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever an automatic headlight beam level control system DTC is stored, the headlight ECU sub-assembly LH stores the current vehicle state as freeze frame ...

    Other materials:

    Toyota CH-R Service Manual > Pre-collision System: Skid Control Buzzer Circuit (C1A4A)
    DESCRIPTION The millimeter wave radar sensor assembly is connected to the forward recognition camera via CAN communication. The millimeter wave radar sensor assembly operates the pre-collision alarm by sending a buzzer request signal to the pre-collision city buzzer. If the millimeter wave ra ...

    Toyota CH-R Service Manual > Headlight Assembly(for Halogen Headlight): Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2. REMOVE HEADLIGHT ASSEMBLY (a) Apply protective tape around the headlight assembl ...

    © 2017-2019 Copyright www.tochr.net
    0.0169