Toyota CH-R Service Manual: Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT HORN RELAY ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied between terminals 1 and 2

10 kΩ or higher

3 - 5

Battery voltage applied between terminals 1 and 2

Below 1 Ω

If the result is not as specified, replace the horn relay assembly.

    Data List / Active Test
    DATA LIST / ACTIVE TEST PERFORM ACTIVE TEST HINT: Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-i ...

    Lighting (ext)
    ...

    Other materials:

    Toyota CH-R Service Manual > Can Communication System: Check Bus 1 Line for Short to +B
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when no resistance exists between terminal 23 (CA1H) of the central gateway ECU (network gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 8 (CA1L) of the central gateway ECU (network gateway ECU) and t ...

    Toyota CH-R Service Manual > Side Airbag Sensor(for Center Pillar): Components
    COMPONENTS ILLUSTRATION *A w/ Rear Seat Side Airbag *B w/o Rear Seat Side Airbag *1 CENTER PILLAR LOWER GARNISH *2 FLOOR SIDE AIRBAG SENSOR *3 FRONT DOOR OPENING TRIM WEATHER ...

    Toyota C-HR (AX20) 2023-2025 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0066