COMPONENTS
ILLUSTRATION
|
*1 |
REAR DOOR BELT REAR SEAL |
*2 |
REAR DOOR BELT SEAL |
|
*3 |
REAR DOOR GLASS INNER WEATHERSTRIP |
*4 |
REAR DOOR INSIDE HANDLE BEZEL PLUG |
|
*5 |
REAR DOOR REAR FRAME BRACKET |
*6 |
REAR DOOR TRIM BOARD SUB-ASSEMBLY |
|
*7 |
REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL |
- |
- |
ILLUSTRATION
|
*1 |
REAR DOOR FRAME GARNISH |
*2 |
REAR DOOR GLASS RUN |
|
*3 |
REAR DOOR GLASS SUB-ASSEMBLY |
*4 |
REAR DOOR QUARTER WINDOW GLASS |
|
*5 |
REAR DOOR SERVICE HOLE COVER |
*6 |
REAR DOOR WEATHERSTRIP |
|
*7 |
REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY |
*8 |
BUTYL TAPE |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
|
*1 |
REAR DOOR LOWER OUTSIDE STRIPE |
*2 |
REAR DOOR OUTSIDE STRIPE |
|
● |
Non-reusable part |
- |
- |
RemovalToyota CH-R Service Manual > Oil Pressure Sensor: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
oil pressure sensor removal/installation are shown below.
Necessary Procedure After Parts Remov ...
Toyota CH-R Service Manual > Fog Light Assembly: Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL FOG LIGHT BULB
(a) Turn the fog light bulb in the direction indicated by the arrow shown in
the illustration, and ...