Toyota CH-R Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY

(a) Check for looseness.

(1) Lift up the vehicle.

(2) Move the front lower No. 1 suspension arm sub-assembly up and down by hand with a force of 294 N (30 kgf) or more to check that there is no looseness at the front lower ball joint assembly.

HINT:

If the front lower ball joint assembly is loose, replace it with a new one.

    Components
    COMPONENTS ILLUSTRATION *1 FRONT AXLE ASSEMBLY *2 FRONT LOWER BALL JOINT ASSEMBLY *3 COTTER PIN - - ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ...

    Other materials:

    Toyota CH-R Service Manual > Airbag System: Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
    DESCRIPTION The driver side squib 2nd step circuit consists of the airbag sensor assembly, spiral cable with sensor sub-assembly and horn button assembly. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunc ...

    Toyota CH-R Service Manual > Smart Key System(for Entry Function): Open in Front Passenger Side Electrical Antenna Circuit (B27A2)
    DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the front door outside handle assembly RH (electrical key antenna) at intervals of 0.25 seconds. For the front door outside handle assembly RH (electrical key antenna) to detect w ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0084