COMPONENTS
ILLUSTRATION
|
*1 |
NO. 2 PARKING BRAKE WIRE ASSEMBLY |
*2 |
PARKING BRAKE ACTUATOR ASSEMBLY |
|
*3 |
O-RING |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
|
Lithium soap base glycol grease |
- |
- |
ILLUSTRATION
|
*1 |
REAR DISC BRAKE CYLINDER ASSEMBLY |
*2 |
REAR FLEXIBLE HOSE |
|
*3 |
REAR DISC BRAKE PAD |
*4 |
REAR NO. 1 DISC BRAKE ANTI-SQUEAL SHIM |
|
*5 |
REAR NO. 2 DISC BRAKE ANTI-SQUEAL SHIM |
*6 |
REAR DISC BRAKE PAD WEAR INDICATOR PLATE |
|
*7 |
GASKET |
*8 |
REAR DISC BRAKE ANTI-SQUEAL SHIM KIT |
|
*9 |
UNION BOLT |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
ILLUSTRATION
|
*1 |
REAR DISC |
*2 |
REAR DISC BRAKE CYLINDER MOUNTING |
|
*3 |
REAR NO. 1 DISC BRAKE CYLINDER SLIDE PIN |
*4 |
REAR NO. 2 DISC BRAKE CYLINDER SLIDE PIN |
|
*5 |
REAR DISC BRAKE BUSHING DUST BOOT |
*6 |
REAR DISC BRAKE PAD SUPPORT PLATE |
|
*7 |
REAR DISC BRAKE CYLINDER SLIDE BUSHING |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
|
Lithium soap base glycol grease |
- |
- |
ILLUSTRATION
|
*1 |
CYLINDER BOOT |
*2 |
PISTON SEAL |
|
*3 |
REAR DISC BRAKE BLEEDER PLUG |
*4 |
REAR DISC BRAKE BLEEDER PLUG CAP |
|
*5 |
REAR DISC BRAKE PISTON |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
● |
Non-reusable part |
DisassemblyToyota CH-R Service Manual > Front Wheel Alignment: Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after completing the front wheel alignment procedure are
shown below.
Necessary Procedures After Procedure Performed
Replaced Part or Perfo ...
Toyota CH-R Service Manual > Immobiliser System(w/ Smart Key System): Security Indicator Light Does not Blink
DESCRIPTION
The certification ECU (smart key ECU assembly) blinks the security indicator
light (clock assembly) when the immobiliser is set (engine switch off).
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When using the Techstream with the engine switch off, connect the Techstrea ...