PROCEDURE
|
1. |
CHECK SETTINGS |
(a) Check radio receiver assembly setting.
(1) Check that the volume is not set to "0".
OK:
The volume is not set to "0".
| OK | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | |
SET VOLUME TO HIGH |
Noise Occurs
Sound Quality is Bad Only when CD is Played (Volume is Too Low)Toyota CH-R Service Manual > Rear Disc Brake Pad(for Tmc Made): Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
The following procedure is for the LH side.
Use the same procedure for the RH side and LH side.
PROCEDURE
1. PRECAUTION
Click here
2. REMOVE REAR WHEEL
Click here
3. PERFORM REAR BRAKE PAD REPLACEMENT MODE
Click here
4. D ...
Toyota CH-R Service Manual > Vehicle Stability Control System: System Diagram
SYSTEM DIAGRAM
Transmitting ECU (Transmitter)
Receiving ECU
Signal
Communication Method
Skid control ECU (brake actuator assembly)
Steering angle sensor
Steering angle sensor request signal
CAN ...