Toyota CH-R Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT SEAT CUSHION AIRBAG ASSEMBLY RH

(a) Pass the airbag wire harness through the hole.

(b) Install the front seat cushion airbag assembly RH with 3 new nuts.

Torque:

5.5 N·m {56 kgf·cm, 49 in·lbf}

NOTICE:

  • Do not reuse the nuts.
  • Make sure that the front seat adjuster assembly RH is not deformed. If it is deformed, replace it with a new one.

(c) Engage the claw and clamps.

HINT:

Engage the claw first.

2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

Click here

3. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

    Disposal
    DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre ...

    Steering Pad
    ...

    Other materials:

    Toyota CH-R Service Manual > Blower Unit(for Denso Made): Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...

    Toyota CH-R Service Manual > Steering Lock System: Diagnosis System
    DIAGNOSIS SYSTEM DESCRIPTION (a) The steering lock ECU (steering lock actuator or upper bracket assembly) stores DTCs when a malfunction occurs in the system. These DTCs can be confirmed by using the Techstream. NOTICE: When using the Techstream with the engine switch off to confirm ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0093