PRECAUTION
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
---|---|---|
Ignition Switch off |
LOCK |
Off (Lock) |
Ignition Switch ACC |
ACC |
On (ACC) |
Ignition Switch ON |
ON |
On (IG) |
Engine Start |
START |
On (Start) |
PRECAUTION FOR HEADLIGHT BULB REPLACEMENT
(a) If even a thin film of oil is left on the surface of a headlight bulb, its service life will be shortened because the light will burn at a higher temperature. When replacing a bulb, be sure to hold the flanged part of the light so that your hand does not contact the glass part of the light.
(b) As the internal pressure of headlight bulbs is high, dropping, hitting or damaging a bulb may result in it exploding and shattering.
(c) Always prepare a new bulb for immediate replacement. While replacing a bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.
(d) Always replace a bulb with another bulb of the same wattage.
(e) If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.
(f) Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may fill with water through gaps around the socket if the socket is not installed securely.
PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY
(a) When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Toyota CH-R Service Manual > Meter / Gauge System: Parts Location
PARTS LOCATION
ILLUSTRATION
*A
w/ Toyota Safety Sense P
*B
for LED Headlight
*1
THERMISTOR ASSEMBLY (AMBIENT TEMPERATURE SENSOR)
*2
SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
*3
...
Toyota CH-R Service Manual > Rocker Panel Moulding: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL ROCKER PANEL MOULDING
(a) Engage the clips to install the rocker panel moulding as shown in the illustration.
...