KIA Niro: Replacing inner panel fuse

Operation

  1. Turn the vehicle and all other switches off.
  2. Open the fuse panel cover.

Replacing inner panel fuse

  1. Pull the suspected fuse straight out.

    Use the removal tool (1) provided in the main fuse box in the engine compartment.

Replacing inner panel fuse

  1. Check the removed fuse; replace it if it is blown. Spare fuses are provided in the instrument panel fuse panel (or in the engine compartment fuse panel).
  2. Push in a new fuse of the same rating, and make sure it fits tightly in the clips.

INFORMATION

If the headlights or taillights, stoplights, day time running lights (DRL) do not work and the fuses are OK, consult a professional workshop. Kia recommends to consult an authorized Kia dealer/service partner.

Replacing motor room fuse

Replacing blade/cartridge type fuses

Replacing blade/cartridge type fuses

Operation

  1. Turn the vehicle and all other switches off.
  2. Remove the fuse panel cover by pressing the tab and pulling the cover up.

    When the blade type fuse is disconnected, remove it by using the clip (1) designed for changing fuses located in the engine room fuse box. Upon removal, securely insert reserve fuse of equal quantity.

Replacing blade/cartridge type fuses

  1. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, use the fuse puller in the engine compartment fuse panel.
  2. Push in a new fuse of the same rating, and make sure it fits tightly in the clips. If it fits loosely, consult a professional workshop. Kia recommends to consult an authorized Kia dealer/service partner.

    READ NEXT:

     Replacing main/multi fuses

    Operation Turn off the vehicle. Remove the fuse panel cover by pressing the tab and pulling the cover up. Disconnect the negative battery cable. Remove the nuts shown in the picture above. Replace the fuse with a new one of th

     Fuse/relay panel description

     Driver's side fuse panel (Kia NIRO Hybrid)

    For HEV vehicle For PHEV vehicle ICU Junction Block Fuse Name/ Symbol/ Fuse rating/ Circuit Protected AMP / / 30 A/ AMP (Amplifier) P/SEAT DRV/ / 30 A/ Driver Lumbar Support Switch, Driver Power Seat Switch, IMS (I

    SEE MORE:

     Gel pad

    Replacement Remove the damaged silicone gel pad completely on the lens plate of rain sensor. Warning The silicone gel must be fully detached from the rain sensor by rubbing it off with the fingers without any tool. The surface

     Pre-Charge Relay

    Specification Description The Power Relay Assembly (PRA) consists of the positive and negative main relays, pre-charge relay, pre-charge resistor and battery current sensor. It is located inside the battery pack assembly and controls the h