KIA Niro: Checking the inverter coolant level (PHEV)

If frequent additions are required, we recommend that the system be inspected by a professional workshop.

Kia recommends to visit an authorized Kia dealer/service partner.

The inverter coolant level should be in between MAX and MIN when the engine is cooled down. When the coolant level (in the reservoir) is low, we recommend that you contact your authorized Kia dealer/service partner. Use only designated coolant water for electric vehicles.

WARNING

Adding other cooling substances or water might lead to inverter cooling system degradation or even failure.

Changing the coolant

We recommend that the coolant be replaced by an authorized Kia dealer according to the Maintenance Schedule at the beginning of this chapter.

WARNING

Cooling fan

Use caution when working near the blade of the cooling fan. The electric motor (cooling fan) is controlled by coolant temperature, refrigerant pressure and vehicle speed. It may sometimes operate even when the vehicle is not running.

Changing coolant

Have the coolant replaced by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

CAUTION

Put a thick cloth around the coolant reservoir cap before refilling the coolant in order to prevent the coolant from overflowing into engine parts such as the alternator.

Hybrid starter & generator (HSG) belt

Checking the Hybrid Starter & Generator (HSG) belt

We recommend that you have the Hybrid Starter & Generator (HSG) belt inspected or replaced according to the Maintenance Schedule in this chapter by an authorized Kia dealer/service partner.

CAUTION

When the HSG belt is worn out or damaged, replace the belt. Otherwise, it may cause engine overheating or battery discharge.

WARNING

  • Turn the vehicle off while you inspect the engine or Hybrid Starter & Generator (HSG) belt. Otherwise it may result in serious injury.
  • Keep hands, clothing etc. away from the Hybrid Starter & Generator (HSG) belt

    READ NEXT:

     Brake fluid

    Checking brake fluid level (Kia NIRO Hybrid) Checking brake fluid level (Kia Niro EV) Operation Clean the area around the reservoir cap. Periodically check that the fluid level in the brake fluid reservoir is between MIN and MAX

     Coolant

    Check the condition and connections of all the cooling system hoses and heater hoses. Replace any swollen or deteriorated hoses. The coolant level should be filled between the MAX or F and the MIN or L marks on the side of the coolant reser

     Engine clutch actuator fluid

    Checking the engine clutch actuator fluid level (Kia NIRO Hybrid) In normal driving conditions, the actuator fluid level does not go down rapidly. However, oil consumption rate may rise as vehicle mileage increases, and leakage in actuato

    SEE MORE:

     Crankshaft Position Sensor (CKPS)

    Specification Crankshaft Position Sensor (CKPS) Description and operation Description Crankshaft Position Sensor (CKPS) is one of the most important sensors of the engine control system that detects the crankshaft position. Lack of CKPS sig

     Front Wiper Motor

    Front wiper motor Rear wiper motor Front Wiper Motor Repair procedures Removal Front Wiper Motor Remove the cowl top cover. (Refer to Body - "Cowl Top Cover") Disconnect the wiper motor connector (A). Remove th