KIA Niro: Before jump starting (for hybrid vehicle) (Kia NIRO Hybrid)

KIA Niro EV / Hybrid (SG2) - (2021-2023) - Owner's manual / What to do in an emergency / Emergency starting / Before jump starting (for hybrid vehicle) (Kia NIRO Hybrid)

This vehicle does not have a regular 12V battery that needs periodic replacement.

It is lithium ion polymer type integrated into the HEV high voltage battery. The vehicle has a 12V battery protection system that cuts 12V battery from vehicle draw to prevent full discharge.

Using the 12V battery reset switch

Using the 12V battery reset switch

  • Press the 12V Battery Reset switch to reconnect the 12V battery.
  • Start the vehicle within 15 seconds of pressing the 12V Battery Reset switch.
  • After starting the vehicle (READY indicator on), operate the vehicle safely outdoors in ready mode stopped and/ or drive it for 30 minutes total to charge the 12V battery fully.

If you do not start the vehicle immediately after pressing the 12V Battery Reset switch, the power of 12V battery is automatically disconnected after few seconds to save the 12V battery from additional discharge. If the 12V battery is disconnected prior to starting the vehicle, press the 12V Battery Reset switch again and then immediately start the vehicle as explained.

Repeated use of the 12V Battery Reset switch without a sufficient vehicle ON cycle (30 Min+) may cause over discharge of the 12V battery, which will prevent the vehicle from starting. If the 12V battery is over discharged to a point that the reset does not work, try to jumpstart the vehicle.

NOTICE

After starting the vehicle (READY indicator on), the 12V battery is being charged whether the engine is running or not.

Although there is no engine sound, it is unnecessary to depress the accelerator pedal.

The following items may need to be reset after the battery has been discharged or the battery has been disconnected.

See chapter 4 and 5 for:

  • Power Windows
  • Trip Computer
  • Climate Control System
  • Audio System

NOTICE

External power source using 12V battery

The use of external power accessories may reduce performance and function of the vehicle. Especially, the use of dash cameras may shut off the power of the vehicle prior to the dash camera's automatic shut-down.

If the power of the vehicle is shut off, start the vehicle as explained. (refer to "Using the 12V battery reset switch")

    READ NEXT:

     Jump-starting (Kia NIRO Hybrid)

    Condition(s) When the vehicle will not start due to low battery power, you may need to jump start the vehicle. Operation Turn off all unnecessary electrical loads. Make sure the booster battery is 12- volt and that its negati

     Jump-starting (12V battery) (Kia Niro EV)

    Jump-starting (12V battery) Condition(s) When the vehicle will not start due to low battery power Operation Connect the jumper cables as shown. Positive (+) terminal of the flat battery (1) and the booster battery (2). Neg

     If the engine overheats (Kia NIRO Hybrid)

    INFORMATION When the temperature gauge indicates overheating, loss of power or a loud pinging, knocking noise will occur, being the engine too hot. Cooling down the vehicle Operation Stop the vehicle to a safe place. Turn the hazard warni

    SEE MORE:

     Safety Plug Description and operation

    Description Safety Plug is installed on the rear side of the high voltage battery and it can mechanically shut the high voltage circuit off when servicing the high voltage system. (i.e. High Voltage Battery, Power Relay Assembly, HPCU, BMS ECU

     Starting the engine with smart key

    The vehicle will check for the smart key when: The vehicle doors are opened The ENGINE START/STOP button is pressed If the smart key is not in the vehicle, the indicator ( ) and the message will appear on the instrument cluster. WARNIN